**PRE-ORDER FOR DELIVERY IN MAY 2020**
ELATE log headers are manufactured using 1 1/2″ SCH40 steam tube and bends along with out 10mm HA250 steel header flanges.
These headers terminate just behind the last cylinder and can be inverted to face forward if required by putting the left bank ones on the right and the right bank ones on the left .
- Standard log height from the base of flange is approx 82mm.
- Block “Hugger” log height from the base of flange is TBC
After running into some clearance issues with our 1UZ to Z20 Soarer swap it became pretty apparent that we were going to be limited to using log style manifolds and figured others may be in the same boat. We have since decided to do a small run of some standard logs and some extra tight ‘block hugger’ style manifolds if you have absolutely minimal room to move.
The manifolds will be made from 3.6mm wall section SCH40 pipe and bends and painted with high temp paint to help prevent corrosion. No flange will be fitted as these can be either used as a base for a turbo setup or routed with additional bends to suit your install .